applicationsmor.blogg.se

How to disconnect act broadband connection
How to disconnect act broadband connection













how to disconnect act broadband connection how to disconnect act broadband connection

  • Connect the input to one of the LAN ports.
  • Disable DHCP and NAT settings of WiFi Router.
  • To avoid IP conflict, change the IP address of your WiFi router in the same range.
  • You will get the IP address and the connected default gateway). (Connect to network, in command prompt enter ipconfig /all.
  • Get the IP range of the connection which you want to extend.
  • The same method is applicable to other routers also. Here I didn’t changed the default IP address of the ADSL router (192.168.1.1) just used the router as a bridge only. In my case the default IP address of the WiMax CPE is 192.168.0.254 which is used as default gateway. You may be required to enter the IP to your WLAN/Ethernet adaptor of PC/Laptop to establish connectivity (If the network shows “Limited Connectivity”) See the image. Now the device is converted as a simple WiFi access point. Internet connection on this port will be bridged to other three ports as well as WiFi port. Now you can connect Ethernet input cable to one of the four LAN ports of the router. After disabling the setting save it and reboot the router. Here you have to Disable the DHCP server. Go to the LAN sub menu under Advanced Setup. Use the default user id “admin” and password “admin”. Access the Modem Admin page by entering in browser address bar. For this connect the router with your PC with WiFi or Ethernet cable. If you want to use this router as a WLAN access point only, the first step is disabling DHCP. ĭ Link 2730 U is an ADSL Wireless router with one WiFi port and four LAN ports.

    how to disconnect act broadband connection

    I’ve used my spare D Link 2730- U WiFi router as a Wireless Access Point to convert the WiMax connection to a WiFi. To share the connection for multiple PCs you have to use an additional Wireless Router (For WiFi) or LAN switch. In WiMax connection the output of CPE (Customer Premise Equipment) is an Ethernet port, which can be directly connected to PC for accessing internet. Due to prolonged serviceability of underground cables, recently I was compelled to change my BSNL broadband connection to WiMax.















    How to disconnect act broadband connection